+
Back to List
Back to List

SKU: 98LUCKY150SMD

Precision Lux2™

  • Wattage: 50
  • Voltage: 100-277
  • Lumens: 6750
  • Color temperature: 3000K or 5000K
  • Color rendering index: >70
  • Dimensions: 14 1/2"(L) x 6 13/16"(W) x 3 3/16"(H)
  • Lifespan: 70,000 hr.
  • Listings: UL, DLC, IP65
  • Warranty: 7 Years

Installation

The lamp is installed on the tubular arm of the round cross section of 40 to 60 mm diameter.

Prior to the installation, the protective glass or polycarbonate (PC) cover must be removed by loosing the M3 bolts on the bottom part of the lamp. Hold the cover carefully in order to prevent falling out.

The standard cable designed for lamp power supply is NYY (PP00) and:
- 3x1.5 mm2 for electrical protection class I
- 2x1.5 mm2 for electrical protection class II.

Tighten the cable gland enough so that the cable is disabled from moving when pulling on it by hand.

After the cable is hauled, the L, N and PE (GND) conductors should be connected to the marked L, N and PE (GND) terminals within the housing. In case of electrical class II luminaire only L and N conductors should be connected to the apropriate terminals. The terminals are spring type and are designed for connecting the conductor tool-free.

Put the cover back into its slot and press the cover onto the gasket with reasonable force (cca 20 N). Tighten the 4 bolts with moment of approx. 1.5 Nm. Do this with continuing pressure of the other hand to the cover in order to ensure the best possible adherence of the cover to the gasket.

Tighten the housing onto the pipe with the provided clamp and the 4M8 bolt. The bolts go beneath the clamp, while the washer, elastic washer and the nut go on the bolt above the housing. The tightening moment of the nut is 10Nm.

Safety

1. In case of any type of mailfunction contact the manufacturer or his service agent.

2. According to the EN 62778 standard, PrecisionLux family of street LED luminaires is classified as Risk group 2. The luminaire should be positioned so that prolonged staring into the luminaire at a distance close then 1.27m is not expected.

3. The light source (LED module) contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.

4. Installation and maintenance of PrecisionLux LED luminaires shall only be conducted by person qualified and approved by manufactirer. Otherwise, serious injuries or even death is possible.

5. Any type of modifications on the luminaire (outside of the scope described in installation guidelines) is strictly forbidden and leads to loss of warranty.

6. Unauthorized opening of the luminaire’s lid is not advisable and leads to loss of warranty.

Product used inProjects

Instalation of the LED lightning

City of Sisak

Lorem ipsum 1

Lorem ipsum 1
Lorem Ipsum 2

Lorem Ipsum 3

Lorem Ipsum 3